CUSTOM & STRUCTURAL MOUNTING
When The Standard
Range Doesn’t Fit.
Fixed to an existing building. Containers on one side, posts on the other. Spans beyond the standard range. If your site does not suit an off-the-shelf answer, this is where we start.
Most Sites Are Not A Blank Slate
Yards grow over time. There is usually a building on one side, a bank on the other, and a hard corner somewhere in between. We design around what is already there.
Fix To An Existing Building
A custom beam attachment ties the shelter into an existing wall, portal frame or building edge — giving you a lean-to without a second row of posts.
Existing Block Or Concrete Walls
Already have retaining walls or a bunker? In many cases the shelter can mount straight to them.
Combination Mounting
Containers on one side, posts or a wall on the other. Common where ground falls away or access is needed on one flank only.
Large Clear Spans
Beyond the standard range. Our largest to date is a 25m clear span, 30m overall — delivered for Kiwi Lumber.
Uneven Or Sloping Ground
Mounting heights can be stepped or varied side to side rather than requiring the site to be levelled first.
Double Stacked
Two containers high for maximum clearance — used for loaders, tipping trailers and boat building.
From Site Photo To Installed Structure
Site Assessment
Send photos and rough dimensions. We establish what is already on site, ground conditions and your wind region.
Concept & Budget
An indicative layout and budget figure so you can decide whether to proceed before engineering cost is incurred.
Engineering
Site-specific structural design and, where required, structural certification for building approval.
Fabrication
Frame and cover manufactured to the approved design.
Install
We can arrange installation across Australia. Ask us about installers for your area.
CUSTOM & STRUCTURAL
Send us your site.
A couple of photos and rough dimensions is enough to start. If it can be covered, we will tell you how — and if it cannot, we will tell you that too.